Firmware Updates - Rev3 for 1050

Here is where you will find the current information regarding the firmware for the AmmoBot Auto Drive.  We offer update packages for both Windows and Mac.  Please use one of the links below to get the latest version of the firmware for the operating system of your choice.  Firmware updates are compatible with Rev3 controllers for Dillon 1050 ONLY.

Instructions for updating your firmware can be found on the Support menu above.

Latest Version Download Links: Mac     or     Windows

  • 4.2.3 - Compiled 03/27/2020
    • Made changes to help with false positive halts
    • Lengthened the stroke length for some presses
    • Changed how often the kill switch process runs
    • Fixed an issue with resume after pocket obstruction
    • Fixed an issue with resume after extractor jam
    • Added better handling of SCCD in rifle mode
  • 4.1.9 - Compiled 12/15/2019
    • Fixed an issue in 4.1.8 where the stroke length is too short
  • 4.1.8 - Compiled 12/03/2019
    • Better handling of unready state of extractor
      • Requires Extractor Version 00A
    • Minor bug fixes
  • 4.1.7 - Compiled 10/15/2019
    • Basic performance enhancements
    • Capatability with OSX 10.15 Catalina (Mac Version)
  • 4.1.6 - Compiled 09/10/2019
    • Better error feedback for DBOS and SCCD
    • Increased home switch offset
    • Improved short stroke detection
  • 4.1.5 - Compiled 11/05/2018
    • Display SCCD output on screen and fixed line wrap problems
    • Reverse setup for extractor using reverse speed setpoint
    • Lowered slowest run speed
    • Made home run less snappy
    • Reworked home run for older Super 1050 presses
    • Minor bug fixes
  • 4.1.2 - Compiled 5/30/2018
    • DBOS Enhancements
    • Positive braking upon halt
    • Extractor enhancements
    • User-suggested improvements
  • 4.1.0 - Compiled 1/1/2018
    • Added support for SCCD Sensor
    • Better halt code information
    • Addition of Last Direction of Travel Indicator
    • Added functionality to help with powder drops
    • Added “rifle” mode (reset machine with the low primer sensor activated)
    • Faster “Processing Mode” (reset machine with thumb switch activated)
    • Lots of optimizations